AIR-AP1121G-A-K9 with ACS Server Implimentation - Auth works DHCP Doesn't
I have a AIR-AP1121G-A-K9 Access point that we are configuring with a cisco ACS 4.2 server pulling from active directory. Currently we authenticate fine but we can't get a DHCP address. The code on the ap 1121 is c1100-k9w7-tar.123-8.JEA. We a vlan 10 which has all the correct ip-helper info before wired vlan 10 hosts get an ip. The SSID on the ap is configured for vlan 10 but the managment ip of the ap is on vlan 500. I can always put in the native vlan 500 config. Here is how the switchport for the ap is configured.
MDF_3750#show run int fa1/0/48
Current configuration : 131 bytes
switchport trunk encapsulation dot1q
switchport trunk native vlan 500
switchport mode trunk
Is the issue with the code on the ap? I heard about a dhcp issue with these ap's. Thanks
Re: AIR-AP1121G-A-K9 with ACS Server Implimentation - Auth works
Well it looks like you did as much as you can. I would try to do this next. Configure a temporary dhcp on the access point and see if you can you get an IP Address. Also place a sniffer and monitor the port to see if you can see any request or replies. Other than that, you can always try to load a different IOS version and see if that works for you.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...