Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member



I have an Ap 1121G-TO-K9, I don't get you access, I already accomplished the attempt (resetting to the Default Configuration), but even so it didn't work.

When I connect Ap in my Personal Cumputer, he doesn't catch IP.

What should make?

Luiz Abreu

Hall of Fame Super Gold

Re: Air-Ap1121G-A-K9

Hi Luiz,

Can you post your config?

New Member

Re: Air-Ap1121G-A-K9

hello leolaohoo,

how like this, to post the configs? I don't have access the interface of AP.

do you think AP can it is in the way LAP(lightweight)?

Luiz Abreu


Re: Air-Ap1121G-A-K9

Hey Luiz,

I'm not sure what you've tried so far, but you need to give your PC the static address of Plug your PC into your AP's Ethernet interface using a Crossover cable (this is required). Then, open a web browser and try to connect to

The AP only holds the for 5 minutes after boot, so reboot it if you aren't able to get to the address. If this still doesn't work, it likely hasn't been reset to factory defaults. Power it down, hold the MODE button, and turn it on. Hold the MODE button until you the AP lights turn red, which should be after about 30 seconds. Then release it and try the above to connect.

Best of luck!


New Member

Re: Air-Ap1121G-A-K9

Hi Jeff,

I did the procedure that you informed, press the MODE for 30 seconds until lights turn red, can not access the AP. PC configured with and put Gateway pattern, the mask that was used to, start web browse (IE) and I connected and failed.

is another procedure?

Luiz Abreu

Fortaleza-ce, Brazil.

Hall of Fame Super Gold

Re: Air-Ap1121G-A-K9

Have you tried this:

Password Recovery Procedure for the Cisco Aironet Equipment