Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controller

I have configured AIR-AP1252G-E-K9 (lightweight)and AIR-WLC4402-50-K9 controller and connect within same LAN but AP is not showing in the controller, please help

controller configuration is attached

Regards,

Majid

4 REPLIES
New Member

Re: AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controll

Please provide more information e.g:

What software version is running on the WLC?

What is providing DHCP, and what is the scope?

Have you tried any debugs on the controller to see any LWAPP join requests, reaching the controller.

Regards

Re: AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controll

You mention above the part number for a autonomous AP then state it is LWAPP. Was it converted? If it was, is it attaching to the same controller it was initially attached with in the conversion process? If not, the SSC is the issue. You must install the SSC hash on the controller. Next, look at the date and time on the controller to insure accuracy. Next is the AP getting an IP address on the same subnet as the controller management and AP manager interface? If not then insure you get an IP address and enable option 43 or DNS lookup of the controller.

New Member

Re: AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controll

Hi, thanks for your response

A) Yes, I converted the following AP from autonomous to lightweight mode but with the help of (CiscoAironet-AP-to-LWAPP-Upgrade-Tool-v34), not through attaching the controller

B)Please tell me the steps of, how to install SSC hash on the controller and DNS related configs

Thnks & Best regards,

Majid

New Member

Re: AIR-AP1252G-E-K9 access point and AIR-WLC4402-50-K9 controll

Required information is attached

No debugging messages are showing on controller

697
Views
0
Helpful
4
Replies
CreatePlease to create content