I have a large amount of internal 2602i and external 3502e Access Points at one of my sites, I have the following Antenna AIR-ANT5160V-R for 5GHz and AIR-ANT5160V-R for 2,4GHz these have one cable per antenna, plugged in as follows 2.4 in port A and 5 also in the repective port A. The issue I am having is, clients will only connect at a 5GHtz, I have equipment that will only work on b/g, consiquently these fail to connect on the external AP's, as soon as you enter a building, they connect straight away. I have attached the Radio Templates. I am running Prime Infrastructure 1.4 and Controller Code 220.127.116.11
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...