Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIR-CAP3702E-A-K9and WLC5508

Hello,

I have a 5508 WLC with the 7.6.120.0 Software Version.  I connect some new, out-of-the-box AIR-CAP3702E-A-K9 AP's and they show:

CleanAir Admin Status = Enable

CleanAir Oper Status = DOWN

When I go to the "Wireless" Tab, then to "Radios" on the menu and select "Configure" on the AP, CleanAir Admin Status is on "Enable."

Does this mean that the AP is doing the CleanAir?

 

Thank you in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

No the AP is not doing Clean

No the AP is not doing Clean Air if the Oper Status is down.

 

Go to the main 802.11b/g/n and a/n/ac tab and make sure that Clean Air is enabled globally:

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70cleanair.html#wp1162863

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
2 REPLIES

No the AP is not doing Clean

No the AP is not doing Clean Air if the Oper Status is down.

 

Go to the main 802.11b/g/n and a/n/ac tab and make sure that Clean Air is enabled globally:

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70cleanair.html#wp1162863

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

It worked.  Thank you very

It worked.  Thank you very much!

180
Views
0
Helpful
2
Replies
CreatePlease to create content