Allthought AIR-LAP1252AG-T-K9 has gigabit 0 configured to "speed auto" it joins 6509 giga port as Full-duplex, 10Mb/s.
AIR-LAP1252AG-T-K9 configutaion:
#sh run int gigabitEthernet 0
interface GigabitEthernet0
ip address dhcp client-id GigabitEthernet0
no ip route-cache
duplex auto
speed auto
end
#sh interfaces gigabitEthernet 0
GigabitEthernet0 is up, line protocol is up
Hardware is PowerPC 8349 Ethernet, address is 588d.095e.6ea2 (bia 588d.095e.6ea2)
Internet address is 147.65.106.28/24
MTU 1500 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Full-duplex, 10Mb/s, media type is T
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 1/4482/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2000 bits/sec, 4 packets/sec
5 minute output rate 52000 bits/sec, 2 packets/sec
1444763 packets input, 628263327 bytes, 0 no buffer
Received 103776 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1422351 packets output, 839918345 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
50970 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
6509 port configuration:
#sh run int g 9/41
Building configuration...
Current configuration : 146 bytes
!
interface GigabitEthernet9/41
description AP28-Corredor 403 - cabo direto
switchport
switchport access vlan 106
switchport mode access
end
#sh int g 9/41
GigabitEthernet9/41 is up, line protocol is up (connected)
Hardware is C6k 1000Mb 802.3, address is 0015.faca.e8c4 (bia 0015.faca.e8c4)
Description: AP28-Corredor 403 - cabo direto
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, media type is 10/100/1000BaseT
input flow-control is off, output flow-control is off
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:19, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 29020
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 39000 bits/sec, 1 packets/sec
92109946 packets input, 30219611673 bytes, 0 no buffer
Received 417088 broadcasts (206667 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
218838486 packets output, 146798721996 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
#sh int g 9/41 status
Port Name Status Vlan Duplex Speed Type
Gi9/41 AP28-Corredor 403 connected 106 a-full a-10 10/100/1000BaseT
