Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIR-WLC2106-K9 get stock (freezing)

Hi everybody,

We have a AIR-WLC2106-K9 who suddenly stops working. We cant access it trough the web GUI or console, we cant even ping it. All leds stock on green (all of them), and the service go down. After restarting the WLC, it works fine but after 3 to 5 days, it fails again.

It is using 5.0.148.0, but we don't want to go up to 6 cause we are using this image as the standard in all out WLC. We have like 10 of these WLC, all with same image and same config, but we have no problems with anyone else.

I'm adding the sh tech.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: AIR-WLC2106-K9 get stock (freezing)

I would suggest opening a TAC case on getting the box RMA'd, that is of course assuming that you have SN.

2 REPLIES
New Member

Re: AIR-WLC2106-K9 get stock (freezing)

I would suggest opening a TAC case on getting the box RMA'd, that is of course assuming that you have SN.

New Member

Re: AIR-WLC2106-K9 get stock (freezing)

Just what I was thinking. Thanks.

431
Views
0
Helpful
2
Replies