Hi Team, i had a problem with the active (associated) survey in a WLC Deployment. The Airmagnet did not Roam from one AP to another. Has anybody seen this Problem and possibly an Solution? Regards, Michael
I assume you are doing an active survey and associating with a particular SSID. AirMagnet won't roam from one AP to another until the signal strength drops to a very low level. If you want to associate with a particluar AP, then click on the drop down box below the Active radio button and select AP. Then go the the drop down list below the Passive radio button and select the AP you want to survey.
Version 4 does have a roaming option but you have to set criteria for when you want to flip from one AP to the next and this gets a little complicated until you have used it a lot.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...