I am configuring the Access Point and after going through the Express Setup and Express Security pages, and after turning the radios on, the Services page no longer displays HTTP, or any other services. It does however display the following...
" \n'; for (i=0; i "
and that is all.
Any ideas what has happened? I am configuring two of these and each one does this same thing, so I do not believe it to be a hardware error.
The Bootloader version is 12.3(8)JEA.... It seems that when I go to Security-->Admin Access and change the Authentication to "Local User List Only" and then remove the Global Password, the Services page disappears. Unless someone has something better, I think that I will keep a Global Password, but change it. That seems to have worked....
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...