I cannot seem to get this darn AiroNet 1130AG AP to allow 'b' devices. All of the examples I have found are not the same GUI interface as what this one has. I just upgraded the IOS to the lastest as of 5/6/2009. How do I get this to work.
Also are you allowing all the data rates 1,2,5,11 etc ?
Also did you check your client, can it attach to other access points using B
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...