Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Aironet 1131AG can't configure via browser interface

Hello,

I have a brand new 1131AG access point and I am trying to configure it.

I have plugged it into a lynksys router that is providing DHCP and it has given the access point the IP 192.168.1.101.

When I try to connect to this address in my browser it does not connect.

Telnet will not connnect either.

I can ping that address from the computer I am using to try to configure.

Does the web interface need to be enabled in some way?

7 REPLIES
Cisco Employee

Re: Aironet 1131AG can't configure via browser interface

You should be able to browse to the unit.  Verify it is an aIOS (Autonomous IOS) if the part number has "LAP" in it, then it is a Unified

(Lightweight) Access Point otherwise you should be able to easily browse into it.

If still no luck (connect a console cable) 9600,N,8,1 and hold the reset button (it will default) and you can watch it boot up on console

and see what IP it got.

Regards,

Fred

New Member

Re: Aironet 1131AG can't configure via browser interface

Remove the AP from the network and go through the commandline of the AP. Configure the BVI1 interface,give it a static ip addr, because u are using the ip addr of the  BVI1  to goin to the GUI. You can also give ip address to the interface F0 an ip addr from ur DHCP reserved ip addr, because its advice to give ur devices a static ip address so hat it will be easy for u to manage it.

Cheers

New Member

Re: Aironet 1131AG can't configure via browser interface

Hi,

Check if you can access the AP via a https connection.

Perhaps http is disabled.

Good luck

wim

New Member

Re: Aironet 1131AG can't configure via browser interface

You can access the GUI from the https but you need to enable the https.

New Member

Re: Aironet 1131AG can't configure via browser interface

Thanks everyone for your suggestions.

This device is an LAP.

I have tried HTTPS and it doesn't work either.

I have successfully connected to it using the serial console, but there is no command to configure it. Even after I execute "enable" and enter the password, there is no configure command available.

New Member

Re: Aironet 1131AG can't configure via browser interface

Hello, Since 1130AG is a lightwight Access point u need a controller to work with it. Because its Zero configuration.U need a controller

New Member

Re: Aironet 1131AG can't configure via browser interface

Hmmmm got the same situation, my main problem is that after giving the AP a new firmware (downloaded from the WLC) the AP disappears from the "WLC radar" and I end up with an AP uanble to config from the WLC and no way to config it from the CLI.

Any suggestions ??

10723
Views
0
Helpful
7
Replies
CreatePlease to create content