Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

aironet 1200 and AWCVX-MIB.my

(firmware 12.3JEB)

I want to distinguish if an AP is in 802.11 a or b / g mode.

I have tried to get specific information from AWCVX-MIB.my.

For example i have tried to read AWCVX-MIB::awcDot11CurrentCarrierSet,AWCVX-MIB::awcDot11CurrentChannel

objects but the above MIB is not supported ):

The strange thing is that the web interface can distinguish if the radio interface operates at 2.4GHz or 5GHz and also can distinguish the mode a or b/g.

Is there an alternative solution to find this information through SNMP?

3 REPLIES
Cisco Employee

Re: aironet 1200 and AWCVX-MIB.my

You might want to look at the CISCO-DOT11-RADIO-DIAGNOSTIC-MIB and the CISCO-DOT11-ASSOCIATION-MIB to see if they provide the objects you are looking for.

New Member

Re: aironet 1200 and AWCVX-MIB.my

Hello,

I still can't get the information from the above MIBS...

SNMP Output(For 3 connected Clients) - Cisco Aironet 1200 firmware version-->12.3JEB

CISCO-DOT11-ASSOCIATION-MIB::cDot11ClientRadioType.1."gstam-cisco".'.....a' = INTEGER: unknown(1)

CISCO-DOT11-ASSOCIATION-MIB::cDot11ClientRadioType.1."gstam-cisco".'.....'' = INTEGER: unknown(1)

CISCO-DOT11-ASSOCIATION-MIB::cDot11ClientRadioType.1."gstam-cisco".'..~.!y' = INTEGER: unknown(1)

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagTempChannel.1 = Gauge32: 0

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagTempTxPowerLevel.1 = Gauge32: 0

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagMode.1 = INTEGER: 0

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagSettingsEnabled.1 = INTEGER: false(2)

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagTempClientTxPower.1 = Gauge32: 0

CISCO-DOT11-RADIO-DIAGNOSTIC-MIB::cDot11RadioDiagTempDataRateSet.1 = Hex-STRING: 00 00 00 00 00 00 00 00 00 00 00 00

New Member

Re: aironet 1200 and AWCVX-MIB.my

cDot11RadioDiagMode OBJECT-TYPE

SYNTAX INTEGER {

normal(1),

apRadioDiscovery(2),

siteSurveyTempSettings(3),

siteSurveyNonTempSettings(4)

}

Here how to use that apRadioDiscovery..

There is no description about the object value.

277
Views
0
Helpful
3
Replies
CreatePlease to create content