Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aironet 1200: Initial Configuration

Can anyone tell me how they are configuring an Aironet 1200 using HyperTerminal? I start a hyperterminal session and it seems like all that is happening is the cursor is blinking. All I need to do is configure an ip address, subnet mask, and gateway.

1 REPLY
Cisco Employee

Re: Aironet 1200: Initial Configuration

Here is how to access the AP via the console

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1200/accsspts/ap120scg/bkscgch2.htm

If you are getting just a flashing cursor try reloading the AP do you see it boot up on the hyper terminal screen ? This will prove your hyper term config

if so then type s for setup then ex for express setup and then you are away

447
Views
0
Helpful
1
Replies