Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Aironet 1200 pulses between green, orange and red

I was updating the firmware on my cisco aironet access point 1200 and it froze right in the middle of the flash. When I plug the access point in now, the status light pulses between green, orange and red; the radio light blinks red; and the Ethernet light blinks green. Is there any hope for this access point? I need assistance please!!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Aironet 1200 pulses between green, orange and red

6 REPLIES
Hall of Fame Super Gold

Re: Aironet 1200 pulses between green, orange and red

Silver

Re: Aironet 1200 pulses between green, orange and red

If the status LED is pulsing colors like that, does that imply that you loaded lightweight software to the AP? Normally that means that the AP is looking for a controller. If that's the case, you might want to connect the AP to your network and see if it finds your controller. Maybe it didn't get corrupted after all.

What version of IOS were you loading onto the AP?

New Member

Re: Aironet 1200 pulses between green, orange and red

thank you for your reply

i was trying to install c1200-rcvk9w8-tar.123-7.JX9. actually, i left the AP for about 3 hours and as Cisco advised that the update operation takes about 15 mins. and when i lost all the hopes. i disconnected and tried to connected again to the network.

in the end i used console cable with mode botton and TFTP server to restore it. Now IT is working Just Perfect :D

thanks

Hall of Fame Super Gold

Re: Aironet 1200 pulses between green, orange and red

Hi Jeff,

If the LED are flashing like a disco dance floor, then the AP went into ROMMON.

However, if the AP's looking for a controller, the flashing is slower.

New Member

Re: Aironet 1200 pulses between green, orange and red

thank you very much for your reply,

i floowed mode button option with TFTP server and the AP is working just perfect :D

regards

Hall of Fame Super Gold

Re: Aironet 1200 pulses between green, orange and red

Thanks for the ratings too.

2756
Views
0
Helpful
6
Replies
CreatePlease to create content