Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

aironet 1200 upgrade to latest IOS software failed

when I applied the upgrade through the web intreface and rebooted, the three lights are always on indicated a continuous boot, when I connect thru the console port I see only only very primitive commands such as c copy file, l load file, s system status etc, I do not obatin the ap> command prompt and I cannot locate any references to these console commands on cisco's site, any suggestions or pointers on where to look? TIA

1 REPLY
New Member

Re: aironet 1200 upgrade to latest IOS software failed

Hello,

your IOS upgrade failed and you are in a basic, minimal IOS CLI. To get out of there, you need to download an IOS image to your AP, and to do that you have to do a basic configuration:

> set IP_ADDR=xxx.xxx.xxx.xxx

> set NETMASK=yyy.yyy.yyy.yyy

> set DEFAULT_ROUTER=zzz.zzz.zzz.zzz

> tftp_init

> tar -xtract tftp://YOUR_TFTP_IP/YOUR_IOS_FILE_NAME flash:

> set BOOT flash:/YOUR_IOS_FILE_NAME

> boot

this should do the trick. If you want to check your current values, just enter the "set" command alone.

Hope this helps.

PLS rate all posts

Antoine

225
Views
0
Helpful
1
Replies