Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Aironet 1231G basic config question

Hi, we have an Aironet 1231G with IOS 12.3(8) and we have enabled DHCP service with two VLANs, one for management (VLAN1) and another one (VLAN 2) for user IP addressing. We do everything by the config guide book (subinterfaces on both dot11 and FastEthernet etc.) however we want DHCP enabled server on AP to allocate IP addresses to clients on VLAN 2 once requested.

We have noticed that all is fine if we want AP to allocate IPs on management VLAN 1, it does not work when we try to do it for VLAN 2; however we want different VLAN for management and different VLAN for users.

We have also tried on sub-int F0.2 to configure an IP address with no success though since DHCP does NOT allocate IP addresses on VLAN 2, is there some sort of config trick that we are missing or is it something that can not be done on AP? Please note that we have it working with DHCP server enabled on a router and connected via sub-int to AP, in this case air interface dot11 allocates succesfully IP addressing for user VLAN 2.

Any ideas, any help will be really appreciated,

Thanks a lot

Tony

1 REPLY
Bronze

Re: Aironet 1231G basic config question

change the dhcp scope and the interface vlan2 ip addressing it will allocate an address in a new range.

227
Views
0
Helpful
1
Replies