Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I have a 1240AG that shows a red light at the Ethernet and Radio indicator on bottome of unit. Can not connect to it thru the web and ip address. Any ideas on what to do?
That likely means that it has an IOS error. You'll need to console in and see if it's in ROMMON. If it is, perform the following to fix it:
Configure a TFTP server/PC to use the address 10.0.0.2
Place a 1240 autonomous image in the TFTP root directory
Rename the file "c1240-k9w7-tar.default"
Connect the PC to the AP using a crossover cable (a normal should also work)
Turn the AP off, then power it back on while holding the MODE button
Release the button once the AP LEDs turn red
That should load the IOS image back on for you.
Jeff's right. It's it's only red light all the time then the AP is on ROMMON.