Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Aironet 1552E show controllers output

Hi wireless experts,

today I come around with a weird request. Let's say I'm collecting "show controllers" outputs from Aironet 1552E outdoor APs for the 2,4GHz and 5GHz radio interfaces from different regulatory domains (weird what people collects nowadays).

Here's an example for the "-E" regulatory domain

ap#show controllers dot11radio1

[...]

Carrier Set: ETSI (OFDM) (EU) (-E)

Uniform Spreading Required: Yes

Configured Frequency: 5700 MHz  Channel 140 (DFS enabled)

Allowed Frequencies: 5500(100) 5520(104) 5540(108) 5560(112) 5580(116) 5660(132) 5680(136) 5700(140)

Listen Frequencies: 5180(36) 5200(40) 5220(44) 5240(48) 5260(52) 5280(56) 5300(60) 5320(64) 5500(100) 5520(104) 5540(108) 5560(112) 5580(116) 5600(120) 5620(124) 5640(128) 5660(132) 5680(136) 5700(140) 5745(149) 5765(153) 5785(157) 5805(161) 5825(165)

Beacon Flags: 0, Interface Flags 20105, Interface Events 0, Mode 9; Beacons are disabled; Probes are disabled; Backhaul enabled; Backhaul UA disabled

Configured Power: 23 dBm (level 1)

Active power levels by rate

     6.0 to 54.0  , 19  dBm, changed due to regulatory maximum

   6.0bf to 54.0bf, 16  dBm, changed due to regulatory maximum

    m0-2 to m15-2 , 19  dBm, changed due to regulatory maximum

   m16-2 to m23-2 , 0   dBm, changed due to regulatory maximum

    m0-4 to m15-4 , 20  dBm, changed due to regulatory maximum

   m16-4 to m23-4 , 0   dBm, changed due to regulatory maximum

    6.0d to 54.0d , 20  dBm, changed due to regulatory maximum

    m0b2 to m23b4 , 0   dBm, changed due to regulatory maximum

  OffChnl Power: 19, Rate 6.0

Allowed Power Levels:  7 11 17 20 23

[...]

The section of the output I postet above is enough for my needs.

It would be really cool to have the outputs for the 2,4 GHz (dot11radio0) and 5 GHz (dot11radio1) radios for the following regulatory domains:

-C, -A, -Q, -N

If someone stumbles upon this topic with a model from another regulatory domain, feel free to post it here as well

Thank you so much in advance for your help!!!

Best regards

Johannes

363
Views
0
Helpful
0
Replies