I have a Linksys Wireless Router running on 2.4ghz using a DSL Connection. I want to setup an old Cisco Aironet 350 Access Point as either a WIRED Bridge or a Wireless Bridge to boost the signal to my backyard office.
I have the Ciscp AP Ver 11.07 configuration site up. I have it associated, but I do't think its 'acting' the way I want.
An AP can not be used as a Bridge you need a BR350 to do that. Added to this a BR350 will only bridge with another Cisco Bridge,
The AP can do repeater mode which will block the ethernet port but will effectivly increase the range of the wireless side by repeating the signal, once again this feature is outside of the standards so it will only work with another Cisco AP not the linksys
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...