Aironet Bridge / FAST Authentication / Network EAP
Hi All, just a question of thumb. I practice to configure all Autonomous Scenarios, Bridges including. If i try to configure Authentication of a WGB or NR Bridge with the Root Bridge or AP based on EAP-Fast and local Radius, i have to configure Network EAP, why? a.f.a.i.k. this is LEAP, not FAST. Is it used for PAC provisioning? Regards, Michael
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...