02-05-2002 07:59 AM - edited 07-04-2021 10:57 PM
How do I change the channel set to ETSI ? Can this only be done at the factory ?
02-11-2002 11:20 AM
You cant change it. You have to order the right one from Cisco.
02-14-2002 03:05 PM
I would bet that if you had one ETSI-spec unit you could copy the Installation Key from it to others, but you might invalidate the warranty and support agreements.
02-20-2002 02:59 PM
It's not possible to copy an installation key off an AP & then back on... it doesn't work.
If the installation key is deleted, the AP needs to be RMA'd to Cisco.
I'd say copying between APs isn't going to be an option either.
03-03-2002 04:04 PM
I know that's Cisco's position, but I've done it and it works - it just takes several steps and enough luck not to lose power during the process.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: