Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

All Radio Disabled for AP1252AG

Hi,

I have 4500-E serial Catalyst Switch and AP1252AG access point.

WS-X4248-RJ45V (48 Port PoE Card) is installed in 4500-E switch and access point is connected with this switch without power injector. But i am getting LOW power error in AP. AP have 3 radios (2.4 GHz). I have tested with 1 radio also but still i have same problem.

Can you please guide me to solve this problem ?

What power command i have to apply on switch port and AP interface.

Its very urgent please...

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: All Radio Disabled for AP1252AG

Hi Prashant,

From Steve @ Cisco;

Information on the 4500 supporting the 1252 is below:

4500 modules req switch to run 12.2(44)SG or later

WS-X4648-RJ45V-E

WS-X4648-RJ45V+E

power inline port maximum 20000

power inline auto max

From this excellent thread;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&topicID=.ee6e8b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc1c2b6

Hope this helps!

Rob

3 REPLIES
Hall of Fame Super Red

Re: All Radio Disabled for AP1252AG

Hi Prashant,

From Steve @ Cisco;

Information on the 4500 supporting the 1252 is below:

4500 modules req switch to run 12.2(44)SG or later

WS-X4648-RJ45V-E

WS-X4648-RJ45V+E

power inline port maximum 20000

power inline auto max

From this excellent thread;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&topicID=.ee6e8b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc1c2b6

Hope this helps!

Rob

Re: All Radio Disabled for AP1252AG

Dear Rob,

Thanks for immidiate reply. I will make change as per your recommendation.

Prashant

Hall of Fame Super Gold

Re: All Radio Disabled for AP1252AG

If you are running Autonomous image, follow Rob's suggestion. If it's LWAP, then upgrade the controller to the 5.2.X firmware and it will work but with lower power output.

194
Views
0
Helpful
3
Replies
CreatePlease to create content