Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Antenna for AP1200

Is it possible to uses an external outdoor antenna (typically used for a bridge) such as air-ant24120 with the 1200 series access points

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Antenna for AP1200

Hi Tanveer,

It is possible to use the 24120 Antenna with the 1200 series AP's. Have a look at the attached docs;

AIR-ANT24120

This antenna operates in the 2400-2500 MHz band and is designed for use outdoors. The antenna is compatible with Cisco Aironet radio products utilizing a reverse-polarity threaded naval connector (RP-TNC) connector.

This antenna is designed for use with Cisco Aironet access points and bridges but can be used with any 2.4-GHz Cisco Aironet radio device that uses a reverse-polarity threaded naval connector (RP-TNC).

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps469/prod_installation_guide09186a0080148acf.html

Omnidirectional Mast mount outdoor high gain antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 12 dBi. This design uses an elevated center-feed to produce an elevation pattern with very little "squint" or beam-tilt. It is designed to be mounted on a round mast.

Cisco Aironet 1200 Series

Cisco Aironet Antenna Reference Guide

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_data_sheet09186a008008883b.html

Hope this helps!

Rob

Please remember to rate helpful posts.........

1 REPLY
Hall of Fame Super Red

Re: Antenna for AP1200

Hi Tanveer,

It is possible to use the 24120 Antenna with the 1200 series AP's. Have a look at the attached docs;

AIR-ANT24120

This antenna operates in the 2400-2500 MHz band and is designed for use outdoors. The antenna is compatible with Cisco Aironet radio products utilizing a reverse-polarity threaded naval connector (RP-TNC) connector.

This antenna is designed for use with Cisco Aironet access points and bridges but can be used with any 2.4-GHz Cisco Aironet radio device that uses a reverse-polarity threaded naval connector (RP-TNC).

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps469/prod_installation_guide09186a0080148acf.html

Omnidirectional Mast mount outdoor high gain antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 12 dBi. This design uses an elevated center-feed to produce an elevation pattern with very little "squint" or beam-tilt. It is designed to be mounted on a round mast.

Cisco Aironet 1200 Series

Cisco Aironet Antenna Reference Guide

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_data_sheet09186a008008883b.html

Hope this helps!

Rob

Please remember to rate helpful posts.........

145
Views
0
Helpful
1
Replies
CreatePlease to create content