Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP 1041 Conversion from Autonomous mode to Lightweight mode.

We have recently converted 1 Cisco Lightweight AP 1041 to Autonomous mode for site-survey purposes. We now want to convert it back to lightweight mode. Is it possible?

  • Other Wireless - Mobility Subjects
1 REPLY

Re: AP 1041 Conversion from Autonomous mode to Lightweight mode.

pankaj_cisco111,

Is the lightweight image still on flash? It should be unless you manually deleted it. If so, change the boot variable to point to the lightweight image:

1040ap(config)# boot system flash:/

/

Then write mem and reload. It should come up in lw mode.

Justin

831
Views
0
Helpful
1
Replies