I am trying to use my AP with my cable modem. I have upgraded to the proper ios but am still running to a issue. Ideally, I want the AP connected to the cable modem and client would connect to the AP, get an IP and be able to surf the web. Right now, the ap is the only device that gets an IP from the modem (Moto sb5120). How can I enable: (1) the AP to act as a dhcp server and (2) forward web traffic to the modem?
Here is the conf. from the AP. I erased the changes I made during testing. Any help will be appreciated.
Hiya! All Cisco Access Points are bridges, meaning that they simply pass IP traffic from one interface to the other without intervening. It sounds like you're looking for the functionality of a router (to do address translation & DHCP services). These are not part of a 'bridging only' solution.
The AP is a bridge, which means you have to setup DHCP server on the Linksys. Most Cable service providers only allow one IP address to be assigned behind the modem, so thats why. Check the number of DHCP clients you can assign on the linksys.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...