10-21-2008 06:24 AM - edited 07-03-2021 04:39 PM
Hi all, is it possible to disable the light on an AP 1131 AG by software or if not by hardware^
Thanks.
Ben
Solved! Go to Solution.
10-21-2008 06:31 AM
Hi Ben,
Give this a try;
config ap led-state
To enable or disable the LED-State for an access point, use the config ap led-state command.
config ap led-state {enable | disable} {Cisco_AP | all}
Syntax Description
config
Display configurations.
ap
Advanced parameters.
led-state
Enable or disable the LED-State for an access point.
{enable | disable}
Enable or disable the access point's LED-State.
{Cisco_AP | all}
Name of a Cisco lightweight access point or all to specify all access points.
http://www.cisco.com/en/US/docs/wireless/controller/4.1/command/reference/clic1.html#wp2384867
Hope this helps!
Rob
10-21-2008 06:31 AM
Hi Ben,
Give this a try;
config ap led-state
To enable or disable the LED-State for an access point, use the config ap led-state command.
config ap led-state {enable | disable} {Cisco_AP | all}
Syntax Description
config
Display configurations.
ap
Advanced parameters.
led-state
Enable or disable the LED-State for an access point.
{enable | disable}
Enable or disable the access point's LED-State.
{Cisco_AP | all}
Name of a Cisco lightweight access point or all to specify all access points.
http://www.cisco.com/en/US/docs/wireless/controller/4.1/command/reference/clic1.html#wp2384867
Hope this helps!
Rob
10-21-2008 07:58 AM
Hi Rob,
Thanks a lot for your help.
You point me in the right direction.
The exact command for this model is :
config led display off
Thanks again and have a good day.
Ben
10-21-2008 08:12 AM
Good stuff Ben! Thanks for posting back with your actual results (very helpful my friend :)
Cheers!
Rob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide