I am attempting to set up a cisco 1231 to authenticate to a win2k3 box via IAS on the windows box. I have followed the cisco and microsoft documents about setting up PEAP but I am having some issues. I am pushing the info to the clients via GPO and have two test clients. One client sees the SSID broadcasted and has all the correct properties and it says "automatic" in grey when I view the networks but it does not connect. The other client has the correct propertes for the SSID in its wireless config but does not even recognize that the AP is in range and they clients are sitting right beside one another. I see nothing in the EV of the windows box and nothing in the debugging of the AP. It's as if they are not even attemtping, but I stumped as to why. Can someone help me out?
Maybe you should try and set the AP to use a fixed channel of either 1, 6 or 11?
I've experienced that older wireless client NICs are not capable of using some channels which may be selected by the auto channel-selection process. In my example when I used channel 13 then my clients could not even see the SSID nor connect to it if I hardcoded the information to the clients.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...