Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP 521 after conversion from autonomous doesn't work

I have buyed a WLC-526 and three AP521 AP. On the first AP521 I used the "Convert to LWAPP" tab in the configuration drawer, according Cisco procedure and after that I downloaded the c520-rcvk9w8-tar.124-10b.JX.tar image. After the procedure running, the AP521 goes in continous loop reload.

What's wrong? How can I recovery the initial image.

thanks an advance

martog

2 REPLIES
Gold

Re: AP 521 after conversion from autonomous doesn't work

Depends on how far the bootup is going. After the AP is converted to LWAPP it will keep rebooting if it can't find a controller to join.

New Member

Re: AP 521 after conversion from autonomous doesn't work

The WLC 526 is on the same subnet as APs.

martog Thanks

237
Views
0
Helpful
2
Replies