i wolud like to ask about Aironet AIr-CAP1602i-c-k9 , how to setup and assign ip address without controller (standalone) . cause i already configure via console but EXEC general configure # configure terminal not display.
ar 1 00:16:51.973: %CAPWAP-3-ERRORLOG: Did not get log server settings from DHCP. *Mar 1 00:16:51.977: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER AP1c6a.7aac.e691# AP1c6a.7aac.e691# AP1c6a.7aac.e691# AP1c6a.7aac.e691# AP1c6a.7aac.e691# AP1c6a.7aac.e691#? Exec commands: access-profile Apply user-profile to interface capwap capwap exec commands cd Change current directory clear Reset functions clock Manage the system clock crypto Encryption related commands. debug Debugging functions (see also 'undebug') delete Delete a file dir List files on a filesystem disable Turn off privileged commands do-exec Mode-independent "do-exec" prefix support enable Turn on privileged commands exit Exit from the EXEC fsck Fsck a filesystem help Description of the interactive help system led LED functions lock Lock the terminal logging Handles logging operations login Log in as a particular user logout Exit from the EXEC lwapp lwapp exec commands mkdir Create new directory monitor Monitoring different system events more Display the contents of a file name-connection Name an existing network connection no Disable debugging functions partition Partition disk ping Send echo messages pwd Display current working directory release Release a resource reload Halt and perform a cold restart rename Rename a file renew Renew a resource rmdir Remove existing directory save Start to save raise_interrupt_level stack send Send a message to other tty lines set Set system parameter (not config) show Show running system information systat Display information about terminal lines terminal Set terminal line parameters test Test subsystems, memory, and interfaces traceroute Trace route to destination undebug Disable debugging functions (see also 'debug') upgrade Upgrade commands verify Verify a file where List active connections
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...