Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP HWIC Will Not Transmit

Hey There Folks,

I have a 3845 router with an AP HWIC installed. The module doesn't seem to transmit any signal. I'm not picking up a thing. Below is what I have configured. I made it real basic; nothing fancy like my 1200 series AP's have on them. I figured these modules would be a cinch to get working, but I'm not having any luck. Plus, the second dot11radio interface is showing reset and down if I do a "sh ip int br"; not for sure why that's happening either. Maybe my module is faulty or something? This implementation should have been pretty simple.

bridge irb

!

dot11 ssid (ssid removed for sec reasons)

authentication open

guest-mode

!

!

interface Dot11Radio0/2/0

no ip address

!

encryption mode ciphers tkip wep128

!

ssid (removed for sec reasons)

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root access-point

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

!

interface Dot11Radio0/2/1

no ip address

!

encryption mode ciphers tkip wep128

!

ssid (removed for sec reasons)

!

speed basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0 48.0 54.0

station-role root access-point

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

!

interface BVI1

ip address 192.168.240.1 255.255.255.0

ip access-group 100 in

!

!

bridge 1 protocol ieee

Any info as to what I'm doing wrong would be great!

Thanks,

Erik

112
Views
0
Helpful
0
Replies