Hey There Folks,
I have a 3845 router with an AP HWIC installed. The module doesn't seem to transmit any signal. I'm not picking up a thing. Below is what I have configured. I made it real basic; nothing fancy like my 1200 series AP's have on them. I figured these modules would be a cinch to get working, but I'm not having any luck. Plus, the second dot11radio interface is showing reset and down if I do a "sh ip int br"; not for sure why that's happening either. Maybe my module is faulty or something? This implementation should have been pretty simple.
bridge irb
!
dot11 ssid (ssid removed for sec reasons)
authentication open
guest-mode
!
!
interface Dot11Radio0/2/0
no ip address
!
encryption mode ciphers tkip wep128
!
ssid (removed for sec reasons)
!
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root access-point
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
!
interface Dot11Radio0/2/1
no ip address
!
encryption mode ciphers tkip wep128
!
ssid (removed for sec reasons)
!
speed basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0 48.0 54.0
station-role root access-point
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
!
interface BVI1
ip address 192.168.240.1 255.255.255.0
ip access-group 100 in
!
!
bridge 1 protocol ieee
Any info as to what I'm doing wrong would be great!
Thanks,
Erik
