Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP IOS upgrade and can't associate ?

Hi NetPro,

After IOS upgrade , this AP can not Associate anymore.

Previous IOS version : flash:/c1240-k9w7-mx.123-7.JA5/c1240-k9w7-mx.123-7.JA5

Proposed IOS Version : c1240-k9w7-tar.124-10b.JDA3.tar

AP Model : AIR-AP1242AG-E-K9

Interface IP-Address OK? Method Status Protocol

BVI1 10.68.151.15 YES NVRAM up up

Dot11Radio0 unassigned YES NVRAM initializing down

FastEthernet0 unassigned YES NVRAM up up

P/S : Radio keep initializing status .

your reply will be highly appreciated.

thanks a lot.

Jack

2 REPLIES

Re: AP IOS upgrade and can't associate ?

Hummm... check the power on the radio.

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Gold

Re: AP IOS upgrade and can't associate ?

Looks like the radio firmware didn't get loaded correctly. Try manually reloading the firmware with the following command:

dot11 dot11Radio 0 recovery-fw flash:c1240-k9w7-mx.124-10b.JDA3/6701.img

Then reload the entire image again. If that doesn't do the trick you'll probably need to RMA the AP.

170
Views
7
Helpful
2
Replies
CreatePlease to create content