Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP stuck in startup - output

Hi, anyone can help on this ?

I power cycle my Cisco Access Point (Aironet 1200 series) connected thru console cable to my PC.

On Hyperterminal, I notice that after certain initialization outputs the startup process 'freezes' always at the same point. I already did power cycle the device multiple times, no improvement.

I use my console cable and PC to successfully manage other devices, therefore I am ruling out that as being the problem.

Any ideas why this is happening to my access point and how can I fix it ?

Please find attached output of hyperterminal captured at the moment where the output from the startup 'freezes'.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: AP stuck in startup - output

What settings to do you have on your terminal emulator? Should be 9600, none, 8, 1 and no flow controll.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
3 REPLIES
Green

Re: AP stuck in startup - output

Is the AP operational? Can you connect to the WebGUIthrough either the Ethernet port or wirelessly?

Do you have flow control set to "None" on our HyperTerminal?

Let us know

Scott

Re: AP stuck in startup - output

What settings to do you have on your terminal emulator? Should be 9600, none, 8, 1 and no flow controll.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Re: AP stuck in startup - output

Hmmm, I think it was the Hyperterminal setting. I put 'no flow control' and that did it. Thanks all.

166
Views
5
Helpful
3
Replies
CreatePlease to create content