Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP VLAN/Bridging Support

I need to bridge a network segment with 2 VLANS across a medium range wireless link. Currently we have 1231Gs which can do this, however they seem to only support one VLAN in WGB mode.

Is there any configuration in which the 1231G supports multiple VLANs over a bridged link? If not would the 1240 series be our best bet?

5 REPLIES
Bronze

Re: AP VLAN/Bridging Support

Jeff

Sounds like you have an old IOS version the current versions support Root and Non-Root bridge roles, and will run mutiple SSID's and VLANs.

Use the GUI for configuration and you will do fine.

HTH

Bill

New Member

Re: AP VLAN/Bridging Support

Is it possible to do this with a 1010AG-LWAPP or 1130AG-LWAPP as ROOT and Fat 1130AG on the NON-Root. Thanks!

New Member

Re: AP VLAN/Bridging Support

Thanks for the information, does the 1230 support the same configuration or is it limited by it's RAM?

Bronze

Re: AP VLAN/Bridging Support

As far as I know it will work on all 123x AP's, the real test is if you load the current version or at least 12.3 (8). If the option for the Root or Non Root role is available in the radio configuration it should work.

Good luck

Bill

Bronze

Re: AP VLAN/Bridging Support

It is probably dooable but the 1010 and 1130 AP's are designed for use in an office environment and may not survive the environmental extreams found in typical bridge installations.

Bill

152
Views
0
Helpful
5
Replies
CreatePlease to create content