Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

AP1010 doesn't connect to the 4100 WLC

Hello, I have a WLC using 3.2.116.21 Firmware and i have also 2 AP1010-E-K9 LAP. Both AP doesn't startup in the right way. The LEDs get red, then green, then off for a longer while with a lot of network traffic, then red again. After that the same procedure starts up again. What can i do to get them working again?

181
Views
0
Helpful
0
Replies
CreatePlease to create content