Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1100 WGB

Trying to connect AP100 in WGB mode to a Qwest AP with WEP KEY. Using Doc ID: 68472 as reference. The radio shows down and not sure how to trouble shoot?

Any help would be great..

Thanks Matt

1 REPLY
Silver

Re: AP1100 WGB

By default, the SSID of the Workgroup Bridge is tsunami, and it tries to acquire an IP address over the wireless link through DHCP. Wired Equivalent Privacy (WEP) is off by default. If an IP address is already configured, you might make a Telnet connection or browse to that IP address. These default settings apply to a 350 series WGB that run the firmware version 8.89.

You can also reset the WGB to factory defaults, with the use of a paper clip on the small reset hole, and then use the default address 192.168.200.1 in order to access it if DHCP fails.

114
Views
0
Helpful
1
Replies
CreatePlease to create content