Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
we have AP1130 all these days it is working but today it laptop was connecting when logged in to wireless I found Radio0-not installed Radio1-not installed. apparently it went in to repeater mode. can any one help me pn this
Try configuring it from the CLI:
ap1130# configure terminal
ap1130(config)# interface dot11radio 0
ap1130(config)# interface dot11radio 1
it not showing that interface
Current configuration : 814 bytes
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
enable secret 5 $1$a9ZM$8sgxHJWQeyjsPeL3Ji84F1
no aaa new-model
ip domain name sch.com.au
power inline negotiation prestandard source
username Cisco password 7 047802150C2E
no ip address
no ip route-cache
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
ip address 192.168.1.100 255.255.255.0
ip default-gateway 192.168.1.1
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
line con 0
line vty 0 4
RMA it. The radio controllers are kaput.
Haha, well said Leo.
I'm serious! The radios have "left the building". I had the same thing on a 1242 a few weeks ago. Radio01 is no longer in the "sh ip interface brief" and Radio0 is on "reset" 9 minutes after a reboot.
can you tell me what is RMA
this is my exact problem yesterday...
first time to get this error...
ap's have been working for more than 5 years until yesterday...
hehehe... WOTD... "kaput"