Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1130AG default mode

What is the default mode for AP1131AG,Autonomous or Lightweight Mode.

I am using WLAN controller 4402.

Thanks

1 REPLY
Hall of Fame Super Red

Re: AP1130AG default mode

Hi Samir,

It depends on the part #. The Cisco Aironet 1130AG Series may be ordered with Cisco IOS Software to operate as an autonomous AP or with Lightweight Access Point Protocol (LWAPP). Check out the part numbers (Note LAP1131AG for lightweight).

AIR-AP1131AG-x-K9 Cisco IOS Software 802.11a/g Non-modular IOS AP; Integrated Antennas

AIR-LAP1131AG-x-K9 LWAPP 802.11a/g Non-modular LWAPP AP: Integrated Antennas

From this doc;

http://www.cisco.com/en/US/products/ps6087/products_data_sheet0900aecd801b901c.html

If you ended up with the Autonomous AP, it can be converted to LWAPP using the LWAPP conversion tool.

Hope this helps!

Rob

Please remember to rate helpful posts.....

341
Views
5
Helpful
1
Replies
CreatePlease login to create content