Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1200 Boot Failure

I have a Aironet 1200 that the 3 LEDs blink amber once every second.  I have tried powering up holding the mode button for 30 sec but does not change the behavior of the AP.  It worked for awhile after upgrading the firmware which is leading me to believe that the upgrade was successful.  Is there any way to recover from this failure?

1 REPLY
Hall of Fame Super Gold

Re: AP1200 Boot Failure

HI James,

Unless you console into the AP there's no way of knowing if the AP lost it's config or what.   Turning amber could mean either it's booting, can't find a WLC or some hardware failure.

306
Views
0
Helpful
1
Replies
CreatePlease to create content