please help..i encountered a boot fail status on my AP 1200 access point. The LED indicator displays 3 amber light. I tried to reset the AP using mode button but i receive no response from the unit. Please advise the next steps to revive my AP. Appreciate your help. Thanks
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...