Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ap1200 constantly reboots after upgrading from Vxworks

Hi I recently upgraded an ap 1200 series access point from the vxworks to ios. I noticr the ap just resets over and over repeatedly. I used the procedure on the site to upgrade with out retaining any settings. http://www.cisco.com/en/US/docs/wireless/access_point/conversion/ios/administration/guide/MT_AP_A.html#wp1007074

Reset ethernet port 0...

Reset done!

ethernet link up, 100 mbs, full-duplex

Ethernet port 0 initialized: link is up

Loading "flash:/c1200-k9w7-mx.122-11.JA3/c1200-k9w7-mx.122-11.JA3"...###########

###########################################

any hints or tips on how to resolve it from doing that?

1 REPLY
Silver

Re: ap1200 constantly reboots after upgrading from Vxworks

This looks like a corrupt firmware issue. Try using the mode button method on the AP to reload the firmware on the AP. The procedure is documented at

http://cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43trb.html#wp1038660

149
Views
0
Helpful
1
Replies