Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ap1200 IOS conversion

I have recently upgrade from vxworks to IOS. The conversion tool upgraded to 12.2(11) JA3. I now cannot upgrade to a higher version. When I try to upgrade it never comes back. And when I look at the access point it hasn't been upgraded. I haven't been able to find an answer in any of the cisco documentation. Anybody have an idea?

1 REPLY
Green

Re: ap1200 IOS conversion

After the initial change to IOS, you may have to initiate the next update via the CLI using the archive command (don't forget to shut down the radios first, use the /overwrite and /force reload (it's ALWAYS best to read the Release Notes for gotchas).

The GUI routine for the update can't find enough storage and won't delete the existing image.

I believe that once you get into the higher 12.2's or 12.3's you can use the GUI for the updates again.

Good Luck

Scott

103
Views
0
Helpful
1
Replies