Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP1200 User Manager blocked

I have a few AP1200's which have the WEP keys and User Manager names set, therefore i cannot connect wirelessly. I have tried connecting over console and see the unit boot up, however when i try to enter Setup> Security page it prompts me for a Username, this i do not have.

Is there any way i can 'crack' these? any process whereby i can reboot the units and restore to defaults?

Nick Howells Head of Solutions Sales - Collaboration STS (Structured Technology Services) T: 0116 240 8820 | D: 0116 240 8832 | M: 07764 710396 E: nickh@sts-communications.com | W: www.sts-communications.com
2 REPLIES
Cisco Employee

Re: AP1200 User Manager blocked

Here is the url which dicsuss about password recovery for Access Points

http://www.cisco.com/warp/public/102/wlan/pwrec-2.html#resetap

Above procedure will bring the AP to factory default settings.,

New Member

Re: AP1200 User Manager blocked

Thanks a lot for your help, i'll give that a try.

Nick Howells Head of Solutions Sales - Collaboration STS (Structured Technology Services) T: 0116 240 8820 | D: 0116 240 8832 | M: 07764 710396 E: nickh@sts-communications.com | W: www.sts-communications.com
118
Views
0
Helpful
2
Replies