Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1200 won't use DNS...

Though the right servers are setup, and accessible to all our clients, both the Root and Repeater AP's keep reporting they can't access the DNS servers:

Repeatedly failed to connect to DNS Server. Temporarily DISABLING DNS lookups for 5 minutes. To immediately re-enable, explicitly Disable then re-Enable DNS on the Name Server Setup page.

Any suggestions for troubleshooting/resolving this issue?

Thanks.

2 REPLIES
Silver

Re: AP1200 won't use DNS...

I found the following exerpt in the release notes for the 1200. "To re-enable DNS lookups, select Disabled for the Domain Name System setting on the Name Server Setup page and click Apply. Then select Enabled and click Apply". To read more info about it go here http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1200/accsspts/ap120rn/rn1154t.htm

New Member

Re: AP1200 won't use DNS...

Yes, I had read and found that too and tried it several times, but no improvement.

123
Views
0
Helpful
2
Replies
CreatePlease login to create content