Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP1230 Hot Standby issue

Hello,

I'm setting an AP1230 to be the backup for another Ap1230. I did everything from the Cisco Manual Configuring a Hot Standby. I'm cloning all the parameters from the monitored AP except IP address and Hot Standby setting. My polling is set to every 5 secs and my timeout 600 secs.

My problem is that after 600 secs the Standby becomes active even thought the other AP is still up and running ( I set a wireless terminal to transfer 255 bytes every 2 secs) and I am monitoring the client association.

I don't know why the Standby thinks that the monitored unit is malfunctioning. If you have seen this before please let me hear your experience.

thank you!

  • Other Wireless - Mobility Subjects
1 REPLY
New Member

Re: AP1230 Hot Standby issue

Did you try increasing the polling interval to a higher number. If there a lot on traffic on your netowork, 5 sec polling may not be enough.

115
Views
0
Helpful
1
Replies
This widget could not be displayed.