I'm trying to set an AP1230 to be the backup of another AP1230. They both have the same configuration execept for IP address and in the back-up unit I enabled the HOT STANDBY feature.
The standby unit shows status as timeout and it does not seem to be working as I expect. Of course when I turn the monitored unit off my client is switching to the standby unit not because the standby feature but I believe it is because they have the same SSID.
If you played with Standby Mode please let me know how it works. Thanks!
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...