Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1240 and non Cisco

We have some non Cisco AP's that I am trying to configure a Cisco AP 1240 to associate with.

The radio will not come out of "disabled"

Antenna is connected and I have done the basic config, there is no security set up at all on the existing untit.

What are the basic setup parameters for the raido to assiciate with teh other side?

are there any debugs I could look at?

1 REPLY
Cisco Employee

Re: AP1240 and non Cisco

Hello,

The issue is that Cisco IOS Autonomous APs will only bridge with other Cisco model APs and Bridges. If these APs can act like client then the Cisco AP will associate as a client but this is not common for an AP. Hope this helps.

Regards,

Aaron

112
Views
3
Helpful
1
Replies
CreatePlease to create content