Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1242AG in bridge mode

Dear Sirs.

I'm trying to configure two 1242AG access points in order that they operate in bridge mode.

I set the role of my first AP as Root bridge, when I set the role of the second to non-Root bridge. After this I see that 802.11g interface of the second AP is down, however, I also see that it is enabled. Therefore, APs are not bridging.

Please advise.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: AP1242AG in bridge mode

Good news, don't forget to award points if my post was helpful. : )

3 REPLIES

Re: AP1242AG in bridge mode

First thing to try is to remove all security and see if the non-root bridge will then associate. If so, rebuild the security and test again.

Are there any errors logged on either bridge?

The radio on the non-root will be down until it associates with the root.

New Member

Re: AP1242AG in bridge mode

Removed the security, set SSID used for bridging to Infrastructure SSID and everything begin to work (then implemented WPA-PSK security to bridge link - works OK).

Re: AP1242AG in bridge mode

Good news, don't forget to award points if my post was helpful. : )

549
Views
0
Helpful
3
Replies
CreatePlease login to create content