Nowadays, almost all Cisco switches support the "power negotiation" mode. The default value of Cisco AP uses the "power negotiation mode," but some switches still do not support power negotiation. In such cases, if you plug an 1130 AP into a Cisco switch, and the default of the Cisco AP is the "power negotiation mode," the AP spends approximately 90 seconds as it tries to negotiate power. If the earlier switch "fools" the AP so that it thinks it cannot provide the power "typically through CDP," the AP comes up in "safe mode" basically with the radios disabled, so it draws the least amount of current and allows you to manage the AP.
The power consumption on the AP1240 breaks down like this
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...