Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
The data sheets for the AP1250 states that only one of each (11g or 11a) module can be installed. Clearly this isnt the case! Have two 11a radio modules installed and that works fine!?
I hope this isnt a flaw since this truly gives this product some nice capabilities. Has anyone tried two 11g radios?
I just went through the data sheet and it has only the following information specified.
"2.4-GHz and 5-GHz Radio Modules
Dual radios allow simultaneous operation of 2.4-GHz and 5-GHz wireless networks, offering the greatest number of available channels and therefore the greatest system capacity and scalability."
It has not mentioned anywhere that same radio types cannot be used. Where it is mentioned that way?. Can you point me to that place?
Slow reply but look here:
Scroll down to Product specifications and Table 2 and further down to Modularity. It says that maximum per AP1250 platform is one of each type..